Actions

Difference between revisions of "Physical number"

From Zenitel Wiki

(AlphaCom E7 and AlphaCom M)
(AlphaCom E20 and AlphaCom 80+)
Line 7: Line 7:
  
 
=== AlphaCom E20 and AlphaCom 80+ ===
 
=== AlphaCom E20 and AlphaCom 80+ ===
 +
[[Image:Physical_number_table.jpg‎|thumb|left]]
 
The physical numbers are in the range 1 - 6, and 43 - 138. Since the card positions 2 - 7 are not used in [[AlphaCom E20]] (and [[AlphaCom 80+|80+]]), the physical numbers 7 to 42 and the corresponding default directory numbers 107 - 142 are missing.
 
The physical numbers are in the range 1 - 6, and 43 - 138. Since the card positions 2 - 7 are not used in [[AlphaCom E20]] (and [[AlphaCom 80+|80+]]), the physical numbers 7 to 42 and the corresponding default directory numbers 107 - 142 are missing.
  

Revision as of 23:46, 2 July 2007

Station directory numbers are determined by the physical connection point

Each subscriber point in an AlphaCom exchange has a physical number. The number is determined by the board position and the type of module (master/slave). The number series 101 to 499 and 5000 to 5152 are default directory numbers for all AlphaCom exchanges. The directory numbers are connected to physical numbers in the range from 1 to 552, where the physical numbers are given by the subscriber point on a board in a certain position in a defined module. The directory numbers can be changed by using the AlphaPro programming tool.

AlphaCom E7 and AlphaCom M

In the AlphaCom E7 and the AlphaCom M the physical numbers are in the range 1 - 38. However, physical number 5 and 6 are by default set for audio program input. Physical number 5 and 6 can be changed to station use if required.

AlphaCom E20 and AlphaCom 80+

Physical number table.jpg

The physical numbers are in the range 1 - 6, and 43 - 138. Since the card positions 2 - 7 are not used in AlphaCom E20 (and 80+), the physical numbers 7 to 42 and the corresponding default directory numbers 107 - 142 are missing.

AlphaCom E26 and AlphaCom 138

In the AlphaCom E26 and AlphaCom 138 the physical numbers are in the range 1 - 138. Corresponding default directory numbers are 101 - 238.

IP Stations

IP stations must also be assigned to a physical number in the range of 1 to 552. This number can be any number below 552, but must not overlap star wired station physical numbers.

It is recommended to start the numbering of IP stations from 552 and downwards to avoid occupied number problems if the exchange is extended with more star wired stations later on. In single module AlphaCom E7 the IP Station can start on physical number 37.

VoIP channels

The physical numbers 605 to 634 are logical numbers inside the AlphaCom E, reserved for VoIP channels used by AlphaNet and SIP.

AE1 timeslots

The physical numbers 553 to 604 are reserved for timeslots 7 to 32 when AE1 boards are used.