Actions

Software Upgrade (Edge)

From Zenitel Wiki

Revision as of 15:38, 11 April 2019 by Asle (talk | contribs)
Edge-icon.jpg
icon This article is under construction!


The software of the Vingtor-Stentofon devices in an IC-EDGE System can be mass upgraded in two ways. Either:

  • by using the VS-IMT tool
  • from the Edge Controller

Contact support.usa@zenitel.com to get the latest software version for Edge devices.

Upgrade using the VS-IMT tool

For a detailed procedure, see the VS-IMT Upgrade Stations


Upgrade from the Edge Controller

Prerequisites

  1. A TFTP Server must be available. A TFTP server can be downloaded from here: http://tftpd32.jounin.net/tftpd32_download.html.
  2. Unzip the software package and store the files in a folder on your PC.
  3. Check if your local firewall is not blocking incoming ping/ICMP (Turbine station is pinging TFTP Server during update process)


The upgrade procedure is slightlty different depending on if it is a Turbine device or an INCA device.

Upgrade procedure - Turbine devices

1. Start the TFTP server program and click Browse, and select the folder where the software files are located

TFTP Server - Browse to the folder where the software files are located


2. Log on to the Turbine Station web interface. Default login credentials are admin and alphaadmin. Select Station Administration > Manual Upgrade

3. Enter the IP address of the TFTP server (I.e. the IP address of your PC)

4. Enter the image file name, e.g vsft-5.0.3.0, and click Save settings. Wait a few seconds for the page to refresh, then press Upgrade. This process will upgrade the station firmware.

Load vsft-4.11.3.0 to upgrade the station firmware


The upgrade procedure takes about 3 minutes. The process can be monitored by clicking the Log viewer tab in the TFTP server program.

Note icon If video is not working after having upgraded the Turbine Video Station TCIV-x to firmware version 4.11, see article TCIV - No video after upgrading to v. 4.11



Upgrade procedure - INCA devices