Actions

Difference between revisions of "Starting Up Turbine Station"

From Zenitel Wiki

(How to find the IP Address of a device)
Line 23: Line 23:
  
 
The default mode from factory is "Edge" mode.
 
The default mode from factory is "Edge" mode.
 +
 +
As soon as you know the IP address, you can [[Logging into an IP Station|log into the device]].
  
  
 
[[Category: Turbine - Restore Factory Defaults and Software Upgrade]]
 
[[Category: Turbine - Restore Factory Defaults and Software Upgrade]]

Revision as of 10:25, 21 September 2021

AEIPS.png
Connecting the PC and the Zenitel IP device to a network switch

The Zenitel IP devices feature an embedded web interface, which allows users to log in using a standard web browser.

To access the IP device, your PC and the device have to be connected to a PoE switch using network cables:

  1. Connect the PC to a port on the network switch
  2. Connect the deviceto a PoE port on the network switch


When the IP device is connected to the network, the IP address of the device is automatically obtained in one of two ways:

  1. An IP address is automatically obtained from a DHCP server if there is one.
  2. If there is no DHCP server, a random IP address in the range 169.254.x.x will be assigned.


How to find the IP Address of a device

If the device is not registered to a server, it will speak its own IP address when you press the Call button, a Digit key a DAK key or activate an Input.

During commissioning, the device must be set to operate in the required mode. There are three modes of operation:

  • ICX-AlphaCom mode - the device will register to an ICX-AlphaCom or AlphaCom XE server
  • SIP mode - the device will register to a SIP server
  • Edge mode - the device will register to an Edge server

The default mode from factory is "Edge" mode.

As soon as you know the IP address, you can log into the device.