Actions

Difference between revisions of "TCIA-2"

From Zenitel Wiki

(Configuration)
(Restore Factory Defaults and Software Upgrade)
Line 38: Line 38:
 
*[[VS-IMT Upgrade Stations|Upgrade using the IMT tool]]
 
*[[VS-IMT Upgrade Stations|Upgrade using the IMT tool]]
 
*[[Automatic Software Upgrade|Automatic Software Upgrade (SIP mode only)]]
 
*[[Automatic Software Upgrade|Automatic Software Upgrade (SIP mode only)]]
 +
* [[:Category:IMX28 Release notes|Software Release Notes]]
  
 
==Connectors, Indicators and Dimensions==
 
==Connectors, Indicators and Dimensions==

Revision as of 11:41, 23 June 2022

The TCIA-2 is an IP based intercom with an analog front board intended for areas where exposure of the physical network is unwanted.

The solution is based on a TKIS-2 VoIP kit, where audio and control signals are connected to an interface (TKIA-2), before they are transported to the front unit TCIA-2.

AEIPS.png
Analog over IP Intercom
(1008113020)

Getting started

Connecting the devices

TCIA-2 Connection 1.png

The 8-wire cable provided is used for connecting the TKIA-2 Gateway to the TKIS-2 Intercom. The colorcoded wires serve as a visual aid to connecting to the correct pins at both ends.

  • Using the 8-wire cable, connect the pins on the TKIA-2 to the corresponding pins on the TKIS-2 according to the drawing.

An FTP cable (maximum 60 meters) is used to connect the TKIA-2 Gateway to the TCIA-2 Intercom.

  • Using the FTP cable, connect the RJ45 port on the TKIA-2 to the RJ45 port on the TCIA-2.

Configuration

The station can operate in three different modes, depending on what kind of server the station should register to. Choose one of the links below according to what mode you need to configure.

Station Specific Configuration:

Restore Factory Defaults and Software Upgrade

Connectors, Indicators and Dimensions

Accessories

Software Requirements

This station is fully supported as from AlphaCom version 11.2.3.7