Difference between revisions of "TCP ports used by AlphaPro"
From Zenitel Wiki
| Line 36: | Line 36: | ||
[[Category:AlphaPro Troubleshooting]] | [[Category:AlphaPro Troubleshooting]] | ||
| + | |||
| + | |||
== Related articles == | == Related articles == | ||
[[Reset and Set Node buttons fail]] | [[Reset and Set Node buttons fail]] | ||
Revision as of 11:05, 8 July 2022
Depending on server type (AlphaCom XE or ICX-AlphaCom) and the AlphaPro version, AlphaPro is using different TCP ports when communicating with the server.
If you get an error message in AlphaPro when trying to communicate with the server, check that:
- Node Type is correct in AlphaPro
- That the relevant TCP ports are enabled in the Filters Settings in the web interface of the server.
ICX-AlphaCom server
When using AlphaPro to configure an ICX-AlphaCom system, make sure that Node Type is set to "ICX" in Exchange & System > System:
TCP Ports used (must be enabled in Filters in web interface):
AlphaCom server
When using AlphaPro to configure an AlphaCom XE system, make sure that Node Type is set to "AlphaCom XE" in Exchange & System > System:
TCP Ports used (must be enabled in Filters in web interface):
