Difference between revisions of "TFIE Dimensions & Mounting Instructions"
From Zenitel Wiki
(→Opening the enclosure) |
(→Mounting the unit) |
||
| Line 35: | Line 35: | ||
=Mounting the unit= | =Mounting the unit= | ||
| + | '''Preparation for Drilling''' | ||
| + | The four mounting holes in the onwall box are Ø6.4 mm. Distance: 298 x 130 mm. Size of hole to be drilled depends on whether it is wall or column mounting: | ||
| + | '''Location''' | ||
| + | |||
| + | Make sure there is a clearance of minimum 230 mm on the left for frame movement. | ||
| + | [[File:TFIE Mounting 2.PNG|thumb|200px|left]] | ||
[[Category: Turbine]] | [[Category: Turbine]] | ||
Revision as of 14:13, 13 October 2016
| Dimensions (WxHxD) | Weight | |
| TFIE-x | 346 x 178 x 101 mm | 1.9 kg |
| TFIX-x | 346 x 178 x 101 mm | 1.9 kg |
| TKIE-x | 65 x 100 x 25 mm | 0.1 kg |
TFIE/TFIX Extended Station Dimensions
Opening the enclosure
Loosen the 2 screws securing the front frame to the on-wall box:
Open the enclosure by pulling the front frame out 5 mm, keeping it parallel to the on-wall box. This is necessary to get clearing for the hinges:
Pull the right side of the front frame to fully open the enclosure. Do NOT open the enclosure to the extent that cables between the front and back parts are pulled tight:
Mounting the unit
Preparation for Drilling
The four mounting holes in the onwall box are Ø6.4 mm. Distance: 298 x 130 mm. Size of hole to be drilled depends on whether it is wall or column mounting:
Location
Make sure there is a clearance of minimum 230 mm on the left for frame movement.
