Actions

TKIE - Using the loudspeaker as microphone

From Zenitel Wiki

Revision as of 10:29, 13 November 2019 by Asle (talk | contribs) (Edge system)
AEIPS.png

This article describes how the loudspeaker connected to a TKIE-2 kit also can be used as a microphone.

Wiring diagram

Wiring diagram - The two relays are used to switch between mic input and amplifier output


Minimum loudspeaker impedance is 8 ohms.

Note icon Use a 100pF capacitor in series with the plus-wire to remove the microphone bias


Configuration

The relays of the TKIE switches the loudspeaker. In idle the loudspeaker is connected to the mic input. When the relays are activated the loudspeaker is connected to the amplifier output.

ICX/AlphaCom system

To operate the relays, an event must be created with the TKIE-2 kit as the Event Owner:

The Audio event is used to switch the relays


In the example above the relays are controlled by the SET_IPRCO command. One can alternatively use the RCO command.

When the "Sub-event" = 62, this event will operate the relays when:

  • M-key is pressed during a direct call
  • Group call is received
  • Audio Program is playing
  • Alarm Message is received

Edge system

  • Log on to the Edge Controller, and select Edge Controller > System Configuration > Special Settings
  • Under the Relay column, select Show/Hide Settings for the TKIE kit
  • To operate the relays of the TKIE when using the M-key during a direct call, configure Remote Digit For Relay On and Remote Digit For Relay Off as shown in the screen shot below.
  • If the loudspeaker should distribute group calls, configure Group Call (Edge mode only) and Idle according to the screen shot below.
Note icon The below configuration must be done for both Relay 1 and Relay 2


Relay configuration in Edge mode


Pulse system

  • Log on to the Edge Controller, and select Edge Controller > System Configuration > Special Settings
  • Under the Relay column, select Show/Hide Settings for the TKIE kit
  • To operate the relays of the TKIE when using the M-key during a direct call, configure Remote Digit For Relay On and Remote Digit For Relay Off as shown in the screen shot below.
  • If the loudspeaker should distribute group calls, configure Group Call (Edge mode only) and Idle according to the screen shot below.
Note icon The below configuration must be done for both Relay 1 and Relay 2


Relay configuration in Edge mode