Actions

Difference between revisions of "Tamper switch"

From Zenitel Wiki

Line 1: Line 1:
 
{{APS}}[[file:1008091010.png|200px|thumb|Tamper Switch<br>(100 8091 010)]]
 
{{APS}}[[file:1008091010.png|200px|thumb|Tamper Switch<br>(100 8091 010)]]
 
== Configuration ==
 
== Configuration ==
Create this event for the Tamper Switch:
+
In [[AlphaPro]], create this event for the Tamper Switch:
[[file:TamperSwitchEvent.png|500px|thumb|left|Tamper Switch configuration]]
+
[[file:TamperSwitchEvent.png|500px|thumb|left|Event handler configuration]]
 +
<br style="clear:both;" />
 +
 
 +
The IP Substation must have I/O 3 defined as an input, which is the default setting.
 +
[[file:TamperSwitchWeb.png|500px|thumb|left|Advanced AlphaCom -> I/O Settings]]
 
<br style="clear:both;" />
 
<br style="clear:both;" />
  

Revision as of 10:41, 27 March 2020

APS.png
Tamper Switch
(100 8091 010)

Configuration

In AlphaPro, create this event for the Tamper Switch:

Event handler configuration


The IP Substation must have I/O 3 defined as an input, which is the default setting.

Advanced AlphaCom -> I/O Settings


Mounting

Mounting instruction on Tamper Switch for IP Vandal Resistant Substation TKIE

Step 1: Remove the two nylon nuts shown below

Tamper1.png


Step 2: Attach the supplied spacers

Tamper2.png


Step 3: Mount the tamper switch board

Tamper3.png


Step 4: Move the button GND wire from the the TKIE board to the tamper switch board

Tamper4.png


Tamper5.png


Step 5: Use the supplied wires to connect GND and Input 3 as shown below

Tamper6.png