Actions

Tamper switch

From Zenitel Wiki

Revision as of 10:41, 27 March 2020 by Roarl (talk | contribs)
APS.png
Tamper Switch
(100 8091 010)

Configuration

In AlphaPro, create this event for the Tamper Switch:

Event handler configuration


The IP Substation must have I/O 3 defined as an input, which is the default setting.

Advanced AlphaCom -> I/O Settings


Mounting

Mounting instruction on Tamper Switch for IP Vandal Resistant Substation TKIE

Step 1: Remove the two nylon nuts shown below

Tamper1.png


Step 2: Attach the supplied spacers

Tamper2.png


Step 3: Mount the tamper switch board

Tamper3.png


Step 4: Move the button GND wire from the the TKIE board to the tamper switch board

Tamper4.png


Tamper5.png


Step 5: Use the supplied wires to connect GND and Input 3 as shown below

Tamper6.png