Difference between revisions of "Turbine Compact - Image recovery"
From Zenitel Wiki
(→The USB to Serial cable) |
(→Requirements) |
||
| Line 8: | Line 8: | ||
== Requirements == | == Requirements == | ||
| + | * The application "Turbine Station Production Upgrade Application" installed on a Windows PC. | ||
| + | * A serial connection from the PC to the Turbine Compact board, using a USB to Serial cable | ||
| + | |||
[[File:TurbineRecovery1.PNG|thumb|left|500px|Setup]] | [[File:TurbineRecovery1.PNG|thumb|left|500px|Setup]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
| − | |||
| − | |||
Revision as of 13:13, 17 December 2013
This article describes how the flash image of a Turbine Compact station can be recovered.
Before starting the upgrade process it is important to identify if the bootloader is corrupted or not.
- Corrupted bootloader
- The bootloader is intact
Requirements
- The application "Turbine Station Production Upgrade Application" installed on a Windows PC.
- A serial connection from the PC to the Turbine Compact board, using a USB to Serial cable
The USB to Serial cable
The Turbine station has a TTL level serial interface which we need to connect to during the upgrade process. For this purpose a USB to Serial converter cable can be used. Recommended cable is TTL-232R-3V3 from Farnell.
This cable needs to be slightly modified as per photo below:
- Pin 1 = Black (GND)
- Pin 2 = Orange (Turbine RX)
- Pin 3 = Yellow (Turbine TX)
