Turbine Video Settings

To modify the video settings on the station models TCIV-2, TCIV-3 or TCIV-6, log on to the station web interface and select:

• Advanced AlphaCom > Video (AlphaCom mode), or
• SIP Configuration > Video Setting (SIP/Pulse mode)

Video Mode: This parameter defines whether the video stream will be in either of the two modes: MJPG in http or H.264 in RTP.

• Video Mode H.264 is used when the station is in SIP or Pulse mode.
• Video Mode MJPG is used when the station is in AlphaCom mode.

Enable Video: This parameter defines whether calls made from the station will be video calls.

Lens distortion correction: Enabling this parameter will correct the “fish eye” effect that can occur on the edges of the video image.

Night mode

• Enables night mode when checked

Zoom

• Select the zoom of the camera. Values are 1x or 2.5x

Offset Left Right [-100 100]

• Available when zoom is set to more than 1x. Determines the width of the image.

Offset Up-Down [-100 100]

• Available when zoom is set to more than 1x. Determines the height of the image.

Color saturation [0 255]

• Adjust the colorfulness of a color relative to its own brightness.

Contrast [0 255]

• Contrast adjustment.

Brightness [0 255]

• Brightness adjustment.

Backlight compensation

• Available values 0-5. Default value = 2.

Camera IP address and port

• IP address is fixed and equal to the TCIV IP address. The port (default 8090) can be changed.

Resolution and fps

• Sets pixel resolution and framerate per second.

Enable HTTP basic authentication

• Requires username and password to fetch video when checked (default admin/alphaadmin).