Difference between revisions of "WK20 - 20W Power Amplifier"
From Zenitel Wiki
(→Connectors and Switches) |
(→Connectors and Switches) |
||
| Line 15: | Line 15: | ||
==Connectors and Switches== | ==Connectors and Switches== | ||
| − | [[Image: | + | [[Image:FIG WK20.PNG|left|600px|thumb|Figure 13-13: ''Connectors and switches on Power Amplifier'']] |
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
Revision as of 14:59, 8 September 2009
The amplifier 1000614100 is very designed to amplify the audio of a Stentofon station. The amplifier can be used standalone (speaker only), or it can be used in combination with a station to amplify the speaker signal. It can be used both with IP stations and with analog stations.
Contents
Features
- Output for 1 amplified loudspeaker
- Output level control
Description
The board contains a power amplifier, a potentiometer for adjusting the output volume and an input for switching the amplifier on/off. The symetrical input is matched to the output level on the subscriber board in the AlphaCom exchange.
The amplifier may be constantly on, or switched on and off by the M-key on the calling station. It is recommended that power to the amplifier board is supplied from a separate class II transformer. <br\> In the AlphaCom exchange, brackets must be mounted on the board, in order to fasten to the mounting rail.
The potensiometer "Balance" is to balance out hum and noise, and is preset from factory. Further adjustments are normally not neccessary.
Connectors and Switches
Technical Specifications
| Text | Value |
|---|---|
| Item Number | 1000614100 |
| Input signal level | 1 V - 10 V |
| Input impedance | 6kOhm |
| Output power<br\><br\> | 20 W into 4ohm<br\>12 W into 8 ohm<br\>6 W into 20 ohm |
| Frequency range | 140 - 20.000Hz |
| Max. amplification | 10.5 dB |
| Recommended room temperature<br\> | 0'C to +35'C<br\>+32'F to + 95'F |
| Humidity Range<br\>(non-condensing): | 10% - 90% RH<br\> |
| Dimensions W x H x D<br\> | 75mm x 84 mm x 40 mm<br\>2.9" x 3.3" x 1.6" |