View source for ENA2200 Amplifier

{{AS}}[[File:ENA2200.png|thumb|alt=ENA2200.|500px|The ENA2200 amplifier]]
The '''ENA2200 Amplifier''' is a 2 x 200 watt IP based amplifier that can register to the AlphaCom server over an IP network.

The ENA2200 amplifier operates from a primary 115/230 VAC supply and have automatic uninterrupted switch-over to a secondary 24-48 VDC supply if the primary should fail. The amplifier will continue to operate with full service during and after the switch-over.

The ENA amplifier has two separate loudspeaker channels. Each channel can be addressed separately, i.e. belong to two different zones, or the two channels can be combined into one channel.

The ENA amplifier monitors the speaker lines for shorts, overload and opens. A [[ELTSI-1|Line End Transponder (ELTSI)]] can be used for reliable detection of an open line. More than one ELTSI can be connected to the same line, allowing monitoring of several branches on the speaker line. The amplifier also monitors control inputs, power, temperature, network connections and every other component required for operation of essential services. Faults will be indicated locally on the [[ENA User Interface|amplifier display]] and fault relay, as well as reported to the AlphaCom server which can raise an event or forward the reports to syslog, SNMP and internal log.

The amplifier’s control inputs/outputs and audio inputs can be used locally by the amplifier (e.g. for PTT and audio from a handheld microphone) or can be controlled by the system (e.g. audio input for background music).
== Installation, Mounting and Dimensions ==
* [[ENA Amplifier - Mounting and Installation|Mounting and Installation]]
* [[ENA2200 - Dimensions|Dimensions]]
* [[ENA User Interface|Amplifier GUI Display]]

== Configuration ==
===AlphaCom mode===
* [[ENA Amplifier - Basic configuration (AlphaCom mode)|Getting started (AlphaCom mode)]]
* [[ENA Configuration - AlphaCom mode|AlphaCom mode]]
* [[ENA Amplifier - Monitoring|Amplifier monitoring]]
* [[ENA Amplifier - Report faults to Display Station|Report amplifier faults to Display Station]]
* [[HD audio for background music distribution]]
* [[Distributed Automatic Volume Control (DAVC)]]

===SIP mode ===
* [[ENA Amplifier - Basic configuration (SIP mode)|Getting Started (SIP mode)]]
* [[ENA Configuration - SIP mode|SIP mode]]
* [[ENA Advanced configuration mode (SIP)|Advanced configuration mode]]
* [[Distributed Automatic Volume Control (DAVC) (SIP)|Distributed Automatic Volume Control (DAVC)]]

=== Common Configuration ===
* [[ENA Amplifier - Calibrating the loudspeaker lines|Calibrating the loudspeaker lines]]
* [[ENA amplifier in Bypass Mode]]

== Software Upgrade and Restore Factory Defaults ==
The ENA amplifier is a "Turbine" device, and the software is upgraded in the same way as Turbine Intercom stations.
* [[Turbine Software Upgrade|Upgrade using the web interface of the amplifier]]
* [[VS-IMT Upgrade Stations|Upgrade using the IMT tool]]

Load Factory Default values:
* To load default configuration and reset to DHCP, press and hold the [[ENA User Interface|menu selection knob]] for 20 seconds while booting up the Amplifier.
* Factory Default values can also be loaded via the web interface of the amplifier, from the [[ENA_Configuration_-_AlphaCom_mode#Station_Administration_tab|Station Administration > Reboot]] menu

== Accessories ==
*[[ELTSI-1|ELTSI-1 Line End Transponder ]]

== Related Information ==
* [https://www.zenitel.com/product/ena2200 Additional Documentation on Zenitel.com]

[[Category: Public Address - Network amplifiers]]