View source for VR3G-1(P) Mounting and Dimensions

[[file:VR3G Description.png|right|350px|thumb|VR3G-1 and VR3G-1P stations]]



== Installation ==
VR3G-1 can be powered by PoE. This is done by connecting an Ethernet cable to the '''LAN port''' of the station and a PoE switch.
{{note|If PoE is used, the station must be installed using a shielded Ethernet cable with grounding at the switch end}}

If the switch does not support PoE, a 24VDC power supply can be connected to the stations '''Power Input'''.
{{note|If an external power supply is being used, please make sure the power supply matches the station}}

== Mounting ==
=== Mounting considerations ===
Check the specification of the product for the installation environment.
{{note|To achieve the vandal resistance the station is designed for, the intercoms must be flush mounted.}}
{{note|To ensure the IP66 rating and that nothing can penetrate behind the edge of the intercom, it must be mounted on a surface that is completely planar.}}


=== Flush mounting ===
When flush mounting vandal resistant station, use the [[Backbox 3 Gang - 1008098300|3 Gang Flush Mount back box]].

[[File:3G dimensions.PNG|left|700px|thumb|3 Gang Backbox]]
<br style="clear:both;" />

* Ready one of the pre-punched holes in the backbox for power and network wiring.
* Have the necessary cables ready before starting the mounting procedure

[[File:VR3G-1P Mounting.png|left|700px|thumb|Mounting the VR3G-1(P)]]
<br style="clear:both;" />

# Insert and secure the 3 Gang Flush Mount back box into designated slot in the wall. Make sure that the box is squarely mounted and the front surface flush with the wall surface.
# Plug the Ethernet cable into LAN port on the station. If the switch does not support PoE, a 24VDC Power Supply can be connected to the stations Power Input.
# Mount the Vandal Resistant Station onto the back box with the 6-32 UNC X ¾ fasteners provided. Apply 1.5 Nm / 1.1 lb-ft torque.

{{note|Make sure the Tamper Switch is properly connected to the back end of the back box.}}
{{note|Re-tighten the screws after mounting, as the gasket behind the front plate will get compressed.}}

== Dimensions ==
*Dimensions (HxWxD): 160x114x60mm
*Dimensions after flush mount: 160x114x5mm

[[File:VR3G-1 Dimensions.png|left|700px|thumb|VR3G-1 Dimensions]]
<br style="clear:both;" />

Return to [[Vandal Resistant intercom - VR3G-1]]