View source for COMMAND RESPONSE

{{AI}}
{| border="1"
|-
!style="background:#ffdead;" width="90pt" colspan="2"|COMMAND_RESPONSE
!style="background:#ffdead;" width="100pt"|0x0066
!style="background:#ffdead;" width="30pt"|102	
!style="background:#ffdead;" |AMC 07.00
|-
|colspan="5"|General response message to messages introduced in AMC 07.00 or newer messages.
(COMMAND_RESPONSE is used rather than dedicated XXX_ACK and XXX_NAK messages )
|-
|align=center|1||[[UINT2]]||colspan="3"|The message_id that this message is a response to.
Example: 0x0065 if this message is a response to [[CANCEL_MAIL]].
|-
|align=center|2||[[UINT1]]||colspan="3"|Command status, possible values are:
1 = Command performed successfully. <br>2 = Target was busy, no queuing.

3 = Internal resource was busy, no queuing.

4 = Access not allowed. (OPC: no license)

5 = Target busy, command queued.

6 = Target HW failed/not present (OPC: overlapping registration of same OPC device from different nodes). 
|-
|align=center|3||[[UINT4]]||colspan="3"|Command response options:
Additional information about the execution of the message.  Interpretation of this field is dependent on the message id, see separate descriptions under each message having this message as response.
|-
|}

[[Category: ACDP messages]]
[[AlphaNet_Data_Protocol#General_Exchange_Control|Back to AlphaNet message list]]