View source for ENA Amplifier - Basic configuration (SIP mode)

{{S}} [[File:ENA SIP Drawing.png|thumb|800px|ENA Amplifiers i SIP mode]] 
This article describes the basic configuration required for a Exigo Network Amplifier (ENA) to operate with an SIP server. The ENA Amplifiers are configured through their web interface. <br>
For a more detailed description of various settings and options, see [[ENA Amplifier Configuration (SIP)|ENA Amplifier Web interface - SIP mode]].

== Configure the amplifier ==
=== Registration Settings ===
Use the web browser on a PC to [[Logging into an IP Station|log on to the web interface of the amplifier]], go to '''Main''' > '''Main Settings''', and:
# Set '''Mode''' = "SIP"
# Select the preferred Internet Protocol (IPv4 or IPv6)
# Configure the '''IP Settings''' (IP address) of the amplifier


[[File:ENA main settings.png|thumb|left|700px|The '''Main Settings''' page]]
<br style="clear:both;" />

{{note|To find the IP address of the amplifier, use the Intercom Management Tool, IMT. On older ENA amplifiers with a front display use the [[ENA User Interface|Menu Selection Knob]], and navigate to '''Information''' > '''Network'''. }}

* Go to '''SIP Configuration -> Account/Call''' and configure relevant parameters for the SIP account:
[[File:ENA2060-account-call.jpeg|alt=|left|thumb|1301x1301px|The '''Account/Call Settings''' page]]
<br style="clear:both;" />
<br>

=== Configure Loudspeaker lines ===
In the [[ENA_Amplifier_Configuration_(SIP)#Line_Control|Amplifier Settings > Line Control]], you can configure Loudspeaker Line Voltage to 70 or 100V, enable or disable channels and set a master volume.

=== Multicast Paging ===
To enable and configure multicast paging, see [[Multicast Paging (Edge/SIP)]]



[[Category: Public Address]]