View source for INCA Station Kit Restore Factory Defaults

{{APS}} 
This procedure is applicable for:
* IP Substation Kit - [[IP Substation Kit - 1008090200|1008090200]]
* IP Master Station Kit [[IP Master Station Kit - 1008093000|100809300]]

<div style="text-align:left;"> <youtube width="300" height="180">WP9m-DG0hMU</youtube>  </div>


The unit can be set to use either '''Static IP''' or '''DHCP'''. On the rear side of the PCB there is a red status LED. Pay attention to this LED during the restore procedure:

[[File:Load Defaults without KEY.PNG|right|thumb|800px|Connect a push button between pins 1 and 4]]

== Procedure ==
# Connect a push button ('''KEY1''') between pin 1 and 4 on the P4 connector.
# While pressing the button, power up the station kit and keep the button pressed.
# Release the button '''after exactly 2 flashes''' of the LED.
# Let the LED flash for '''exactly 2 more times''' (Static IP) or '''exactly 4 more times''' (DHCP), then press the button again.
# Keep the button pressed until the LED '''flashes fast 2 times''' (Static IP) or '''flashes fast 4 times''' (DHCP) indicating a successful reset.
# Release the button and the station will restart with the factory default settings.


== Factory default values ==
*Station Mode: '''Pulse'''
*Station IP address: '''169.254.1.100''' or '''DHCP'''
*Username: '''admin'''
*Password: '''alphaadmin'''


[[Category: INCA - Restore Factory Defaults and Software Upgrade]]