View source for IP Hotline Connections (INCA)

==INCA Based==
=== Introduction ===
The table below is an overview of the main connectors involved when installing the IP Hotline Station.

{| border="1"
|-
| align=left | LAN (P1) || 10/100 Mbps RJ45 port for LAN (uplink) connection. Supports PoE (802.3af). Draws power from either spare line or signal line.
|-
| align=left | AUX (P2) || 10/100 Mbps RJ45 port for auxilliary equipment such as PC or IP Camera.
|-
| align=left | Input/Output || Pluggable screw terminal
|-
| align=left | Local Power || Pluggable screw terminal, 17-27 VDC Idle 4W, max. 8W
|-
|}

To access these connectors the front cover must be removed.

[[File:IP Master Station Kit.PNG|right|300px]]
=== Power Supply ===
The IP Hotline Station supports Power over Ethernet (PoE, IEEE 802.3 a-f) where power can be drawn from either the spare line or signal line. 

If PoE is not available, the IP Hotline Station  can be connected to a 24 VDC local power supply. 

See Related Article [[INCA Master Station Kit Board Connectors]] for local power supply connections.

=== Network Connection ===
There are two RJ45 ports on this IP Hotline Station: 
:* LAN port (P1): for connecting to the network and the AlphaCom XE Audio Server.
:* AUX port (P2): for connecting to auxiliary equipment such as a PC or IP Camera.

=== Input/Output Connections ===
There are I/O connection options for the IP Hotline Station. These I/O connections include:

==== P3 - External Loudspeaker, Relay Output and External Power Input ====
6-pin plug-on screw terminal for external connections.
[[File:IP Master Board 2.PNG|left|thumb|200px|P3]]
<br style="clear:both;" />
*Pin 1/2  Connection to the loudspeaker of the handset 
*Pin 3/4  Internal NO relay contact for additional call indication etc.
*Pin 5/6  Connect 24 VDC for station power if PoE is not used. Pin 6 is positive.

==== P4 - Inputs and Station LED ====
6-pin plug-on screw terminal for external connections.
[[File:IP Master Board 3.PNG|left|thumb|200px|P4]]
<br style="clear:both;" />
*Pin 1/4  Input for Hookswitch for handset cradle (and for restoring Factory Default Setting) 
*Pin 2/4  Input 2 (optional)
*Pin 3/4  Input 3 (optional)
*Pin 5/6  Station LED for call message info. (Pin 6 is positive.)

==== J10 - Microphone ====
Connection to handset microphone
[[File:IP Master Board 10.PNG|left|thumb|200px|J10]]
<br style="clear:both;" />
*Pin 1  MIC+ 
*Pin 2  MIC-

Note that the microphone selection switch next to connector J10 should be in the '''left position''', labeled "Int.".


For more details see [[INCA Substation Board Connectors]].

[[Category: INCA Connections]]