View source for IP Station on VLAN with Cisco Catalyst PoE swtich

{{AEIPS}}
[[File:VLAN 1.png|thumb|400px]]
This article shows how to configure an IP Station for use with [[IP_Station_Configuration#VLAN|VLAN]] and a computer attached on the second interface (P2), using Cisco smartport setup.

==Cisco Catalyst 2960 PoE switch config==
VLAN configured on the switch:

*VLAN 100: Prod (PC network)
*VLAN 126: VoIP (IP Station network)

===Configuration with the webinterface===
When the VLANs are configured on the switch you can easily use the smartport setup on the switch to configure the ports for Cisco Phone+Desktop, which will add the correct config on the selected port(s) and also add QoS policy needed to set priority to VoIP traffic on the switch.  You will typical configure all ports the same to make patching easy.

[[File:VLAN 2.PNG|400px]]

As shown in the picture below, VLAN 100, the PC network, will be configured as the "Access VLAN", so that if you should patch a computer to the switch port instead of an IP Station Phone, you will still have access. If you attach an IP Station, the IP Station will receive the "Voice" LAN and forward the PC VLAN to the attached PC, if the IP Station is configured correct.

[[File:VLAN 3.PNG|400px]]

===Configuration with CLI===
Needed CLI config to setup Cisco Smartports:
 mls qos srr-queue output cos-map queue 1 threshold 3 5
 mls qos srr-queue output cos-map queue 2 threshold 3 3 6 7
 mls qos srr-queue output cos-map queue 3 threshold 3 2 4
 mls qos srr-queue output cos-map queue 4 threshold 2 1
 mls qos srr-queue output cos-map queue 4 threshold 3 0
 mls qos

 macro global description cisco-global
 errdisable recovery cause link-flap
 errdisable recovery interval 60

 vlan internal allocation policy ascending

 interface FastEthernet0/1
 description Phone+Desktop
 switchport access vlan 100
 switchport mode access
 switchport voice vlan 126
 switchport port-security maximum 2
 switchport port-security
 switchport port-security aging time 2
 switchport port-security violation restrict
 switchport port-security aging type inactivity
 mls qos trust cos
 macro description cisco-phone
 spanning-tree portfast
 spanning-tree bpduguard enable

==IP Station config==
The IP Station [[IP_Station_Configuration#VLAN|VLAN]] is given priority creating QoS for VoIP.
===Configuration with webinterface===

[[File:VLAN 4.PNG|500px|thumb|left|VLAN configuration]]

[[Category:INCA Technical Articles]]