View source for Main Settings - Edge Controller

{{E}}
This article describes how to configure a Zenitel IP device to act as an '''[[Edge Controller]]'''. 

{{note| 
* ''Most Zenitel IP devices can act as an Edge Controller, see [[Edge Controller|full list here]]''
* ''You can do all configuration of your devices from the Edge Controller. There is no need to log on to each device''
* ''The Edge Controller should use a Static IP Address, not obtain IP address from a DHCP server'' }}

* [[Logging into an IP Station|Logging on to the device you will use as the Edge Controller]]
* Select '''Main''' > '''Main Settings''' to access the page for configuring Mode of operation and Network Settings.
[[File:Edge MainSettings2.PNG|thumb|left|700px|Setting the Edge Controller]]
<br style="clear:both;" />

'''Mode:''' Select the mode ''Edge Controller''

'''Product Model And Accessory:''' Depending on the type of Turbine hardware, there are different Product models and accessories to choose from. Find your model here: [[:Category:Stations#Turbine_stations|Turbine Station Models]]

'''IP Settings:'''
* '''Static IP''' – The Edge Controller must be assigned a Static IP address. Enter values for:
** '''IP-address'''
** '''Subnet-mask'''
** '''Gateway''': The controller must have a valid Default Gateway address defined.
*** If there is no gateway in the network, you can enter the same IP Address as the Static IP Address. A valid gateway address is important for the [[Group Call (Edge)|Group Call feature]].
** '''DNS Server 1''': (option for network administration)
** '''DNS Server 2''': (option for network administration)
** '''Hostname''': (option for network administration)

* '''Disable Reset to Factory default settings using frontboard and I/O :''' If enabled, factory reset will only be possible from StationWeb. This is disabled by default. 
*'''Read IP Address:''' When enabled an unregistered station will speak its IP address when the call button is pressed. "Read IP Address" is default enabled.
*'''Enable RSTP''' (for Industrial & Ex stations): Check the '''Enable RSTP''' box to enable Rapid Speanning Tree Protocol RSTP. RSTP is only required when using redundant networking
*'''Ethernet Speed 10 Mbits/s''': Enable in some rare cases where it is not convenient to use 100 MBit/s Ethernet speed. Default Ethernet speed is 100 Mbit/s unless switch is configured to 10 Mbit/s.
*'''IGMP Version [Desktop v2, IP FlushMaster v2 and IP-CROR v2 only]:''' Select IGMPv2 or IGMPv3 for multicast group membership.

Click '''Save''' to apply the new configuration settings.

[[Category: IC-EDGE Configuration]]