View source for Situations that require System Reset

A number of AlphaPro settings require that the system is reset or rebooted in order to make the change take effect. 

The [[AMC-IP]] card is using [[Linux]] as operative system (OS). A number of applications are running on top of Linux. One of these applications is the intercom (AMCd) application. Examples of other applications are [[SIP]], [[Syslog (AlphaCom)|Syslog]], [[AlphaWeb]] (web server) and [[RMD|RingMaster interface]].
=== Types of reset ===
There are two types of reset available from AlphaPro and AlphaWeb:
* Reset of the AMC application. This will restart the intercom application only. An AMC reset takes approx. xx seconds in a fully equipped E7, and xx seconds in a fully equipped E26.
** From AlphaPro: Press the 'Reset' button in the [[Communicate (alphaPro)|AlphaPro Communication Window (WACS)]]
** From AlphaWeb: Press 'Small Reset' in the System Maintenance -> System Recovery menu
* Reboot the exchange. This will restart the Linux operative system and all applications. A reboot takes approx. xx seconds in a fully equipped E7, and xx seconds in a fully equipped E26.
** From AlphaWeb: Press 'Reboot' in the System Maintenance -> System Recovery menu
** Press the reset button on [[APC]] (E20 and E26) or on the power board (E7)
** Recycle the power (switch power off, then on)

===Situations that require AMC application reset===
* Adding a new IP station in [[Users_%26_Stations_%28AlphaPro%29#General|Users & Stations]]
* Change of volume setting of an analog station (Changing the volume of an IP station do not require reset)
* Enabling [[RCO]]. Reset is required when a RCO is changed from device 0 / pin 0.
* Adding a SIP node
* Adding a node in AlphaNet
* Adding a module in MultiModule (i.e. after having entered the IP Address of the slave module in Exchange & System > System)

===Situations that require Linux reset===
* 


===Situations that don't require reset or reboot, but where the change take effect after a short time===
* Changing or adding a new directory number
* Event Handler programming. It may take up to 1 minute before the change takes effect. (The change will take effect immediately if the AMC application is reset)

[[Category:AMC Software]]