View source for Temperature Alarm

{{A}}
==Temperature alarm==
The AlphaCom XE monitors the temperature of the boards. If the temperature becomes too high, an internal [[RCI]] #8 is triggered, and the log event "Temperature Alarm" is generated:
 Oct 10 12:54:35 src@Johnson AlphaLog: N001.D065:.Exch:ALARM 8 ON.
 Oct 10 12:54:35 src@Johnson AlphaLog: N001.D065:.Exch:Temperature Alarm

In addition a mail is sent to the station on [[physical number]] 1. The mail can be viewed by entering [[Stationreset feature|70 (Station reset)]] and looks like this:

 TemperatureAlarm
 0=Clear 8=Call


==MultiModule==
By default RCI 8 in the Master module is programmed to report Temperature Alarms. This needs to be done manually for the slaves. The RCI for the Master module is number 65/8. Slave 1 is 66/8, slave 2 is 67/8 and slave 3 is 68/8.




==Known problems with AMC-IP hardware revision 8000/2==
"Temperature Alarm" is reported when the AlphaCom E7 is powered ON: 
* The hardware revision 8000/2 of the AMC-IP board has no support for the over-temperature signal from the ACE7 backplane. This is applicable for the E7 exchange only, and has been corrected in the 8002/4 hardware revision of the AMC-IP. The hardware revision is printed on the rear side of the AMC-IP, top right corner.
* A workaround is to delete the ON and OFF action for RCI #8 to avoid "Temperature Alarm" to be reported to station #1 when powering on the AlphaCom E7.
[[File:Temp alarm.PNG|thumb|left|700px|Delete ON and OFF action if "Temperature Alarm" should not be reported to station #1]]

[[Category: AlphaCom Troubleshooting]]