View source for ZIPS-kit

{{ACEIS}}[[File:ZIPS-kit.jpg|thumb|400px|ZIPS-K (1016324)|alt=]]
This article serves as a Getting Started guide for '''ZIPS-K''' Indoor IP Speaker Kit and '''ZIPS-KOE''' Outdoor IP Speaker Kit:
* '''ZIPS-K''': Item 1016324, Indoor IP Speaker Kit
* '''ZIPS-KOE''': Item 1016325, Outdoor IP Speaker Kit (IP-66)

For complete documentation on mounting and installation, please read the [http://www.zenitel.com/product/zips-kit Mounting & Installation Manual].

In general Zenitel offers a number of IP based kits, which can be used for a wide range of applications. See the [[Kits - Comparison chart|kit comparison chart]].
==Getting started==
* [[Starting Up Turbine Station|Starting up]]

==Configuration==
The device can operate in [[Main Settings (IP Stations)|different modes]]. Set the mode according to the server the station should register to.
* [[IP Station Configuration - ICX-AlphaCom mode|ICX-AlphaCom mode]]
* [[Adding station to existing system (Edge)|Edge mode]]
* [[SIP Intercom - Web Interface|SIP mode]]
{{note|To use this device with [[:Category:Zenitel Connect Pro|Zenitel Connect Pro]] it must be factory defaulted. The device configuration is done from the Zenitel Connect Pro server.}}

==Connectors and Dimensions==
* [[ZIPS - Board Connections|Device Connections]]
* [[ZIPS-kit Dimensions|Dimensions]]

== Mounting considerations==
The ZIPS-K and ZIPS-KOE are intended for integration into a suitable enclosure, panel or emergency point assembly. 

The speaker kits shall be mounted on a flat, stable and vibration-resistant surface. 

Speaker openings, microphone openings, status indicators and service interfaces shall not be blocked by the enclosure, gaskets, adhesives, membranes or cables. 

When both speaker and microphone are used, provide sufficient acoustic separation between them. Avoid mounting the microphone directly in front of, behind or in the same open cavity as the speaker. Poor acoustic separation may cause echo, feedback or  reduced speech intelligibility. 

Route microphone cables away from speaker cables, relay wiring and other noise generating cables. Use shielded cable where required by the installation environment

=== Outdoor mounting considerations ===
The IP66 rating is only valid when ZIPS-KOE is installed according to the [http://www.zenitel.com/product/zips-kit Mounting & Installation Manual], using the specified gaskets, cable glands, and seals.

<br>

==Restore Factory Defaults and Software Upgrade==
*[[ZIPS - Restore Factory Defaults|Restore Factory Defaults]]
*[[TCIV+ Software Upgrade|Upgrade via the devcie web interface]]
*[[IMT - Discover & Upgrade|Upgrade using the IMT tool]]
*[[Automatic Software Upgrade|Automatic Software Upgrade (SIP mode only)]]
* [[:Category:IMX8M Nano Release notes|Software Release Notes]]


==Related Information==
*[http://www.zenitel.com/product/zips-kit Mounting & Installation Manual on Zenitel.com]

[[Category: Turbine]]