Difference between revisions of "Operating the TEIV-1+"

Revision as of 12:41, 20 June 2024

To define a pin code – create a csv file with 4 digits numbers as shown in the example below:

A maximum of 30 pin codes can be uploaded
When saving the CSV file the seperation character should be defined as semicolon (;).
Upload the pin code list file under the Address Book menu as shown below

Encrypted pin codes are stored here: http://[IP address of the station]:8080/state/config/gui/door_access_control

Make sure port 8080 port in the device firewall is opened

Making a call – Dial the wanted extension number on the numeric keypad. In SIP Mode, the Check mark may be required to indicate the end of the dialing sequence
Call using address book – use the check mark after selection is done
Door Opening - Dial #, followed by your Pin Code. This will activate the built-in relay.

Making a call – Dial “#” followed by the number to be called, then the checkmark (v), e.g. # 201 v
Call using address book – use the check mark after selection is done
Door Opening - Dial your Pin Code. This will activate the built-in relay.

@@ Line 23: / Line 23: @@
 ===Prior to VS-IS 8.2.3.1===
-* To make a call – you need to press “#” followed by the number to be called to and then the checkmark (v), e.g. # 201 v
+* '''Making a call''' – Dial “#” followed by the number to be called, then the checkmark (v), e.g. # 201 v
-* To make a call using address book – use the checkmark after selection is done
+* '''Call using address book''' – use the check mark after selection is done
-* To activate a relay from keyboard, you need to press a pin code (e.g. 4 digits).
+* '''Door Opening''' - Dial your Pin Code. This will activate the built-in relay.