Difference between revisions of "Operating the TEIV-1+"
From Zenitel Wiki
(→Using the station) |
(→Using the station) |
||
| Line 17: | Line 17: | ||
== Using the station == | == Using the station == | ||
| − | === | + | ===From firmware version 8.2.3.1=== |
* '''Making a call''' – Dial the wanted extension number on the numeric keypad. In SIP Mode, the Check mark may be required to indicate the end of the dialing sequence | * '''Making a call''' – Dial the wanted extension number on the numeric keypad. In SIP Mode, the Check mark may be required to indicate the end of the dialing sequence | ||
* '''Call using address book''' – use the check mark after selection is done | * '''Call using address book''' – use the check mark after selection is done | ||
* '''Door Opening''' - Dial #, followed by your Pin Code. This will activate the built-in relay. | * '''Door Opening''' - Dial #, followed by your Pin Code. This will activate the built-in relay. | ||
| − | ===Prior to | + | ===Prior to version 8.2.3.1=== |
| − | * '''Making a call''' – Dial “#” followed by the number to be called, then the | + | * '''Making a call''' – Dial “#” followed by the number to be called, then the check mark (v), e.g. # 201 v |
* '''Call using address book''' – use the check mark after selection is done | * '''Call using address book''' – use the check mark after selection is done | ||
* '''Door Opening''' - Dial your Pin Code. This will activate the built-in relay. | * '''Door Opening''' - Dial your Pin Code. This will activate the built-in relay. | ||
Revision as of 12:42, 20 June 2024
Contents
Defining PIN code(s)
- To define a pin code – create a csv file with 4 digits numbers as shown in the example below:
- A maximum of 30 pin codes can be uploaded
- When saving the CSV file the seperation character should be defined as semicolon (;).
- Upload the pin code list file under the Address Book menu as shown below
|
Encrypted pin codes are stored here: http://[IP address of the station]:8080/state/config/gui/door_access_control
Make sure port 8080 port in the device firewall is opened |
Using the station
From firmware version 8.2.3.1
- Making a call – Dial the wanted extension number on the numeric keypad. In SIP Mode, the Check mark may be required to indicate the end of the dialing sequence
- Call using address book – use the check mark after selection is done
- Door Opening - Dial #, followed by your Pin Code. This will activate the built-in relay.
Prior to version 8.2.3.1
- Making a call – Dial “#” followed by the number to be called, then the check mark (v), e.g. # 201 v
- Call using address book – use the check mark after selection is done
- Door Opening - Dial your Pin Code. This will activate the built-in relay.