Difference between revisions of "1-1a. Exchange startup (solution)"
From Zenitel Wiki
(→Power:) |
(→Coldstart:) |
||
| Line 14: | Line 14: | ||
===Coldstart:=== | ===Coldstart:=== | ||
| − | *Press and hold the coldstart button on the AMC-IP board | + | *Press and hold the [[Autoload|coldstart]] button on the AMC-IP board |
*Press the reset button on the power card briefly | *Press the reset button on the power card briefly | ||
*Keep the cold start button pressed at least 2 sec. after reset. | *Keep the cold start button pressed at least 2 sec. after reset. | ||
Revision as of 23:21, 26 February 2011
Practice 1-1a:
Cards:
- Insert the ASLT card in position 1.
- Insert the AMC-IP card in position 7.
Power:
- Connect the power source to the plug on the back of the exchange, marked 24 VAC IN
- Connect the mains cable to the wall outlet
- Observe the exchange starting
Coldstart:
- Press and hold the coldstart button on the AMC-IP board
- Press the reset button on the power card briefly
- Keep the cold start button pressed at least 2 sec. after reset.
- The AMC status LED will blink green when the boot is ready.