Difference between revisions of "1-3b. IP Stations – Substations (solution)"
From Zenitel Wiki
(→Exercise) |
(→Configure the IP Substation) |
||
| Line 13: | Line 13: | ||
* Assign the PC an IP address in the range 169.254.x.x | * Assign the PC an IP address in the range 169.254.x.x | ||
* Connect the PC to the network switch | * Connect the PC to the network switch | ||
| − | + | [[File:1-3b solution1.png|thumb|left|250px|Accessing the IP Substations web page]] | |
| − | |||
| − | [[File:1- | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
* When prompted, '''Save''' the changes. When asked for "Restart now" you can select "No". | * When prompted, '''Save''' the changes. When asked for "Restart now" you can select "No". | ||
| Line 23: | Line 21: | ||
* When prompted, '''Save''' the changes. | * When prompted, '''Save''' the changes. | ||
* Step to the menu selection '''Restart''' and activate a restart of the station | * Step to the menu selection '''Restart''' and activate a restart of the station | ||
| − | |||
===Configure the AlphaCom XE=== | ===Configure the AlphaCom XE=== | ||
Revision as of 16:46, 22 March 2011
Configure the IP Substation
- Perform a "Factory Default" setting on the IP Substation
- Press the call button
- While the button is pressed, connect the IP Substation to the PoE switch
- Wait until the call LED of the station starts to flash
- Release the call button for exactly two flashes
- Push the button briefly
- Assign the PC an IP address in the range 169.254.x.x
- Connect the PC to the network switch
File:1-3b solution1.png
Accessing the IP Substations web page
- When prompted, Save the changes. When asked for "Restart now" you can select "No".
- Step to the menu selection AlphaCom IP and enter the following parameters:
- When prompted, Save the changes.
- Step to the menu selection Restart and activate a restart of the station
Configure the AlphaCom XE
- In AlphaPro go to Users & Stations, and select physical number 37; 137 Station 37
- Use the section on the right and change the configuration as follows:
- In AlphaPro go to Users & Stations, and select physical number 38; 138 Station 38
- Use the section on the right and change the configuration as follows:
- Send the changes to the AlphaCom XE
