Difference between revisions of "INCA Station Kit Restore Factory Defaults"
From Zenitel Wiki
(→Restore with Static IP) |
|||
| Line 19: | Line 19: | ||
# Release the button and the station kit will restart with the factory default settings. | # Release the button and the station kit will restart with the factory default settings. | ||
| − | + | Factory default values: | |
| − | + | *Station Mode: '''Pulse''' | |
| − | + | *Station IP address: '''169.254.1.100''' | |
| − | + | *Username: '''admin''' | |
| − | + | *Password: '''alphaadmin''' | |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
* Software 01.06 and earlier: '''ADMIN/alphacom''') | * Software 01.06 and earlier: '''ADMIN/alphacom''') | ||
| − | |||
== Restore with Activated DHCP == | == Restore with Activated DHCP == | ||
Revision as of 13:01, 17 March 2017
This procedure is applicable for:
- IP Master Station Kit 100809300
- IP Substation Kit - 1008090200
- IP Heavy Duty station 1008072xx0
The Factory Default can be either set to Static IP 169.254.1.100 or activate DHCP.
Connect a push button (KEY1) between pin 1 and 4 on the P4 connector.
Restore with Static IP
- While pressing the button, power up the station kit.
- When the station kit LED starts blinking, release the button after exactly 2 blinks.
- Let the LED blink for exactly 2 more times, then press the button again.
- Keep the button pressed until the LED blinks fast 2 times indicating a successful reset with static IP.
- Release the button and the station kit will restart with the factory default settings.
Factory default values:
- Station Mode: Pulse
- Station IP address: 169.254.1.100
- Username: admin
- Password: alphaadmin
* Software 01.06 and earlier: ADMIN/alphacom)
Restore with Activated DHCP
The DHCP option is available from software version 01.07.
- While pressing the button, power up the station kit.
- When the station kit LED starts blinking, release the button after exactly 2 blinks.
- Let the LED blink for exactly 4 more times, then press the button again.
- Keep the button pressed until the LED blinks fast 4 times indicating a successful reset with activated DHCP.
- Release the button and the station kit will restart with the factory default settings.
| Factory default values | |
|---|---|
| Station Mode | Pulse |
| Station IP address | determined by DHCP server |
| AlphaCom IP address | 169.254.1.5 |
| Username* | admin |
| Password* | alphaadmin |
* Software 01.06 and earlier: ADMIN/alphacom)