Actions

Difference between revisions of "Flowire"

From Zenitel Wiki

(Reset to Factory defaults)
Line 1: Line 1:
 +
{{APS}}
 +
[[file:FCDC1.jpg|363x231px|right|TCIS-1]]
 
Flowire is based on the [https://en.wikipedia.org/wiki/HomePlug#HomePlug_AV HomePlug AV] power line communications specification, only using 24 - 48 V DC as the medium. It is a network bridge between Ethernet and a PLC link.
 
Flowire is based on the [https://en.wikipedia.org/wiki/HomePlug#HomePlug_AV HomePlug AV] power line communications specification, only using 24 - 48 V DC as the medium. It is a network bridge between Ethernet and a PLC link.
 
[[File:FCDC1.jpg|363x231px|center]]
 
  
 
There are two variants
 
There are two variants

Revision as of 11:06, 6 September 2017

APS.png
TCIS-1

Flowire is based on the HomePlug AV power line communications specification, only using 24 - 48 V DC as the medium. It is a network bridge between Ethernet and a PLC link.

There are two variants


Factory defaults

  • Static IP address : 169.254.1.10
  • DHCP enabled. If obtain an dynamic address, it comes in addition to the static address.
  • NMK Password: HomePlugAV0123

MAC address range: 00:13:CB:0A:00:00 -> 00:13:CB:0A:80:00

Reset to Factory defaults

Flowire can be reset to Factory defaults by pressing the button for 15 seconds. The recessed button is located next to the Ethernet connector. (Handled by managerd process.)