Difference between revisions of "SET CALL REQ MODE"

Latest revision as of 15:07, 3 October 2019

SET_CALL_REQ_MODE		0x006C
$SCRM L101 L102 U0 U1
Turn on/off message "your call is registered, please wait", then ring/flashing at a station. Note that the station leaves this mode if becomes busy for some reason (dialing, incoming conv.) "Call requester mode" is normally used to inform the user about a successful activation of call request.
1	NET_OBJ_REF {ECL_STATION}	Station
2	NET_OBJ_REF {ECL_STATION}	Station that received the call request mail (i.e. sender of this command)
3	UINT1	UserDefined Properties (UDP) of the station that received the call request mail.
4	UINT1	New call requester mode: 0 = off 1 = on
5	UINT1	Mail Priority 0 - 255
6	UINT1	Mail Flags: SEND_MAIL
7	NET_OBJ_REF (Optional 13.1.3.1)	Custom Voice message for call request as parameter. Format N!!<message id>. Note : L<dirno> (e.g. L8194) is not supported.
Response:		COMMAND_RESPONSE

@@ Line 1: / Line 1: @@
-{{A}}
+{{AI}}
 {| border="1"
 |-
@@ Line 22: / Line 22: @@
 |-
 |align=center|6||[[UINT1]]<br />||colspan="2"|Mail Flags: [[SEND_MAIL | SEND_MAIL]]
+|-
+|align=center|7||[[NET_OBJ_REF]] <br> (Optional 13.1.3.1)<br />||colspan="3"| Custom Voice message for call request as parameter. Format N!!<message id>. Note : L<dirno> (e.g. L8194) is not supported.
 |-
 |colspan="2"|Response:||colspan="3"|[[COMMAND_RESPONSE]]