Actions

Difference between revisions of "Flowire"

From Zenitel Wiki

m
Line 3: Line 3:
 
Flowire is based on the [https://en.wikipedia.org/wiki/HomePlug#HomePlug_AV HomePlug AV] power line communications specification, only using 24 - 48 V DC as the medium. It is a network bridge between Ethernet and a PLC link.
 
Flowire is based on the [https://en.wikipedia.org/wiki/HomePlug#HomePlug_AV HomePlug AV] power line communications specification, only using 24 - 48 V DC as the medium. It is a network bridge between Ethernet and a PLC link.
  
There are two variants:
+
There are three variants:
 +
*[[FCDC-3]] (1008080110 )
  
 +
The versions
 
*[[FCDC-1]] (1008080110 ) - Forwards power to the spare pairs of the Ethernet port
 
*[[FCDC-1]] (1008080110 ) - Forwards power to the spare pairs of the Ethernet port
 
*[[FCDC-2]] (1008080210) - Does not forward power to the Ethernet port
 
*[[FCDC-2]] (1008080210) - Does not forward power to the Ethernet port
Line 13: Line 15:
 
*DHCP enabled. If the unit obtains a dynamic IP address, it comes in addition to the static address.
 
*DHCP enabled. If the unit obtains a dynamic IP address, it comes in addition to the static address.
 
*NMK Password: '''HomePlugAV0123'''
 
*NMK Password: '''HomePlugAV0123'''
 
MAC address range: 00:13:CB:0A:00:00 -> 00:13:CB:0A:80:00
 
  
 
<br><br>
 
<br><br>

Revision as of 08:11, 31 January 2020

APS.png
Flowire

Flowire is based on the HomePlug AV power line communications specification, only using 24 - 48 V DC as the medium. It is a network bridge between Ethernet and a PLC link.

There are three variants:

The versions

  • FCDC-1 (1008080110 ) - Forwards power to the spare pairs of the Ethernet port
  • FCDC-2 (1008080210) - Does not forward power to the Ethernet port
Note icon The FCDC-1 is directly forwarding the power from the Power Supply Unit to the Ethernet port (802.3af Type 1 mode B only). This means it is using the spare pairs only for power, and there is no auto-sensing of polarity or load. It is not using PoE (Power over Ethernet) technology


Factory defaults

  • Static IP address : 169.254.1.10
  • DHCP enabled. If the unit obtains a dynamic IP address, it comes in addition to the static address.
  • NMK Password: HomePlugAV0123



Reset to Factory defaults

Flowire can be reset to Factory defaults by pressing the button for 15 seconds. The recessed button is located next to the Ethernet connector.



Related Information