Difference between revisions of "1-1a. Exchange startup (solution)"
From Zenitel Wiki
(→Related articles) |
|||
| (2 intermediate revisions by one other user not shown) | |||
| Line 15: | Line 15: | ||
*Press and hold the [[Autoload|coldstart]] button on the AMC-IP board | *Press and hold the [[Autoload|coldstart]] button on the AMC-IP board | ||
*Press the reset button on the power card briefly | *Press the reset button on the power card briefly | ||
| − | *Keep the cold start button pressed at least 2 sec. after reset | + | *Keep the cold start button pressed at least 2 sec. after reset |
| − | *The AMC status LED will blink green when the | + | *The AMC status LED will blink green when the system is up and running |
| + | |||
| + | ===Station connection=== | ||
| + | *Connect the two master stations to physical port number 1 and 2 | ||
| + | *Call the other station by dialling the directory number shown in the display | ||
<br><br><br><br> | <br><br><br><br> | ||
| Line 23: | Line 27: | ||
===Related articles === | ===Related articles === | ||
* [[1-1a. Exchange startup (practice)]] | * [[1-1a. Exchange startup (practice)]] | ||
| + | |||
| + | [[Category: AlphaCom practice]] | ||
Latest revision as of 09:02, 30 June 2022
Cards
Power
- Connect the power source to the plug on the back of the exchange, marked 24 VAC IN
- Connect the mains cable to the wall outlet
- Observe the exchange starting
Coldstart
- Press and hold the coldstart button on the AMC-IP board
- Press the reset button on the power card briefly
- Keep the cold start button pressed at least 2 sec. after reset
- The AMC status LED will blink green when the system is up and running
Station connection
- Connect the two master stations to physical port number 1 and 2
- Call the other station by dialling the directory number shown in the display