Difference between revisions of "IP Flush Master Gooseneck"
From Zenitel Wiki
(→Related articles) |
|||
| (15 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | [[File: | + | {{AEIPS}} |
| − | + | [[File:1008097500.PNG|thumb|300px|Gooseneck Microphone. item no 1008097500]] | |
| − | |||
| − | + | This microphone is for | |
| + | * [[IP Flush Master -V2]] | ||
| + | * [[IP Master Station Kit - 1008493000|IP Master Station Kit -V2]] | ||
| + | * [[IP Flush Master - 1008031000|INCA IP Flush Master Station]] | ||
| + | * [[IP Master Station Kit - 1008093000|INCA IP Master Kit]] | ||
| + | |||
| + | To install the Gooseneck Microphone: | ||
* Remove the cover plug from the opening for the microphone on the front panel. | * Remove the cover plug from the opening for the microphone on the front panel. | ||
* Thread the microphone cable through the opening, the lock washer and nut. | * Thread the microphone cable through the opening, the lock washer and nut. | ||
| Line 10: | Line 15: | ||
* Slide the '''S1''' switch (bottom back of station) to '''EXT''' to activate the external microphone function. | * Slide the '''S1''' switch (bottom back of station) to '''EXT''' to activate the external microphone function. | ||
| − | + | For board connectors, see: | |
| + | * [[IP Flush Master -V2 Board Connectors]] | ||
| + | * [[INCA Master Station Kit Board Connectors]] | ||
| − | [[File:IP_Master_Gooseneck_Microphone_Installation.PNG]]<br/> | + | [[File:IP_Master_Gooseneck_Microphone_Installation.PNG|350px]]<br/> |
Installing the Gooseneck Microphone | Installing the Gooseneck Microphone | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
| + | |||
| + | |||
| + | [[Image:IP_Flush_Gooseneck_Mic_Connection1.JPG|300px|thumb|left|Gooseneck microphone connection]] | ||
| + | [[Image:IP_Flush_Gooseneck_Mic_Connection2.JPG|200px|thumb|left|Gooseneck microphone connection, detailed]] | ||
| + | <br style="clear:both;" /> | ||
| + | |||
| + | == Related articles == | ||
| + | * [http://www.zenitel.com/product/crm-v-gn Additional Documentation on Zenitel.com] | ||
[[Category: INCA Backboxes and accessories]] | [[Category: INCA Backboxes and accessories]] | ||
| + | [[Category: Turbine Backboxes and accessories]] | ||
Latest revision as of 14:28, 2 May 2023
This microphone is for
To install the Gooseneck Microphone:
- Remove the cover plug from the opening for the microphone on the front panel.
- Thread the microphone cable through the opening, the lock washer and nut.
- Tighten the nut on the microphone’s threaded stud.
- Insert the microphone’s IDC socket into the upper two pins of the 3-pin header (J7) located at the lower left side of the station. The signal wire (white) should be on the top pin while the ground wire (green) should be on the bottom pin.
- Slide the S1 switch (bottom back of station) to EXT to activate the external microphone function.
For board connectors, see:
Installing the Gooseneck Microphone
