Difference between revisions of "Active Noise Cancellation (ANC)"
From Zenitel Wiki
(→ICX-AlphaCom mode) |
(→ICX-AlphaCom mode) |
||
| Line 18: | Line 18: | ||
== ICX-AlphaCom mode == | == ICX-AlphaCom mode == | ||
| − | + | In an ICX-AlphaCom system the Active Noise Cancellation is configured from AlphaPro. Select the Users & Stations window. | |
| − | + | In the field Noise Reduction, select the value "1" to enable the feature, or "0" to disable. | |
| − | |||
[[File:NoiseReduction AlphaPro.png|thumb|left|700px|Enabling AVC on a device in ICX-AlphaCom mode]] | [[File:NoiseReduction AlphaPro.png|thumb|left|700px|Enabling AVC on a device in ICX-AlphaCom mode]] | ||
Revision as of 13:35, 23 October 2023
|
This article is under construction! |
Active Noise Cancellation (ANC) is a feature in the Zenitel IP devices. The purpose of the ANC is to cancel out the surrounding background noise and at the same time keep the voice signal intact.
Typical background noise could be noise from an air conditioner, a factory floor or a truck engine.
The Active Noise Cancellation ANC feature is by default active, hence there is normally no need to do any configuration.
IC-Edge mode
Log in to the Edge Controller, and navigate to Edge Controller > System Configuration > Call and Audio. The ANC feature can be disabled (or enabled) per device under the column "ANC":
ICX-AlphaCom mode
In an ICX-AlphaCom system the Active Noise Cancellation is configured from AlphaPro. Select the Users & Stations window.
In the field Noise Reduction, select the value "1" to enable the feature, or "0" to disable.
SIP mode
Log in to the Zenitel IP device, and navigate to SIP Configuration > Audio Settings, and enable "Automatic Volume Control (AVC)":
