Difference between revisions of "Operating the TEIV-1+"
From Zenitel Wiki
ZenitelAus (talk | contribs) |
(→Using the station) |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{AEIS}} | {{AEIS}} | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
== Defining PIN code(s) == | == Defining PIN code(s) == | ||
| Line 25: | Line 13: | ||
{{Note|Encrypted pin codes are stored here: http://[IP address of the station]:8080/state/config/gui/door_access_control | {{Note|Encrypted pin codes are stored here: http://[IP address of the station]:8080/state/config/gui/door_access_control | ||
Make sure port 8080 port in the device firewall is opened}} | Make sure port 8080 port in the device firewall is opened}} | ||
| + | |||
| + | |||
| + | == Using the station == | ||
| + | |||
| + | ===From firmware version 8.2.3.1=== | ||
| + | * '''Making a call''' – Dial the wanted extension number on the numeric keypad. In SIP Mode, the Check mark may be required to indicate the end of the dialing sequence | ||
| + | * '''Call using address book''' – use the check mark after selection is done | ||
| + | * '''Door Opening''' - Dial #, followed by your Pin Code. This will activate the built-in relay. | ||
| + | |||
| + | ===Prior to version 8.2.3.1=== | ||
| + | * '''Making a call''' – Dial “#” followed by the number to be called, then the check mark (v), e.g. # 201 v | ||
| + | * '''Call using address book''' – use the check mark after selection is done | ||
| + | * '''Door Opening''' - Dial your Pin Code. This will activate the built-in relay. | ||
Revision as of 12:42, 20 June 2024
Contents
Defining PIN code(s)
- To define a pin code – create a csv file with 4 digits numbers as shown in the example below:
- A maximum of 30 pin codes can be uploaded
- When saving the CSV file the seperation character should be defined as semicolon (;).
- Upload the pin code list file under the Address Book menu as shown below
|
Encrypted pin codes are stored here: http://[IP address of the station]:8080/state/config/gui/door_access_control
Make sure port 8080 port in the device firewall is opened |
Using the station
From firmware version 8.2.3.1
- Making a call – Dial the wanted extension number on the numeric keypad. In SIP Mode, the Check mark may be required to indicate the end of the dialing sequence
- Call using address book – use the check mark after selection is done
- Door Opening - Dial #, followed by your Pin Code. This will activate the built-in relay.
Prior to version 8.2.3.1
- Making a call – Dial “#” followed by the number to be called, then the check mark (v), e.g. # 201 v
- Call using address book – use the check mark after selection is done
- Door Opening - Dial your Pin Code. This will activate the built-in relay.