IP Flush Master DAK-48 Module: Difference between revisions
From Zenitel Wiki
No edit summary |
No edit summary |
||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
{{AI}} [[File: | {{AI}} [[File:D48-newZ.png|thumb|400px|DAK-48 Unit. Item number: 1008010100]] | ||
The '''IP DAK-48 unit''' expands the: | The '''IP DAK-48 unit''' expands the: | ||
* [[IP Flush Master -V2]] | * [[IP Flush Master -V2]] | ||
| Line 43: | Line 43: | ||
* [http://www.zenitel.com/product/crm-v-dak48 Additional Documentation on Zenitel.com] | * [http://www.zenitel.com/product/crm-v-dak48 Additional Documentation on Zenitel.com] | ||
[[Category: | [[Category: Backboxes and accessories]] | ||
Latest revision as of 10:43, 14 October 2025
The IP DAK-48 unit expands the:
with an additional 48 Direct Access Keys. Up to two DAK-48 units can be connected to one station.
Software and license requirements
Software:
- IP Flush Master (INCA): Version 01.09.3.0 or later
- IP Flush Master (Turbine): Version 6.0.3.0 or later
- AMC-IP: Version 10.60.3.0 or later
License: To enable the use of the DAK48 module a license is required:
- 1009648001: License for CRM-V DAK expansion
Regardless if the CRM-V station is using one or two DAK48 modules, only one CRM-V DAK expansion license is required.
|
The DAK-48 module is supported in ICX-AlphaCom mode only, not in Edge, Pulse or SIP mode. |
Installing the DAK-48 Expansion module
To interconnect the DAK-48 unit to the main unit, use the cable which is coming with the DAK-48 unit. The DAK-48 unit receive its power and data via this cable.
|
A standard patch cable (1:1) must not be used. It might damage the unit! |
Installing the IP DAK-48 Unit:
- Power off the IP Flush Master station by disconnecting the ethernet cable in the LAN port
- Plug one end of the cable coming with the DAK-48 unit into the RJ45 port on the right hand side of the IP Flush Master station (when the station is viewed from the front).
- Plug the other end of the cable into the left RJ45 port on the DAK-48 unit (when the unit is viewed from the front).
- Power up the IP Flush Master station by connecting the ethernet cable to the LAN port
To add a second DAK unit, plug one end of an RJ45-RJ45 cable into the RJ45 port of the installed unit and plug the other end into the RJ45 port of the new unit.