Relay Settings (SIP): Difference between revisions
From Zenitel Wiki
No edit summary |
No edit summary |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
To configure relay operation, select '''SIP Configuration''' > '''Relay/Outputs'''. | To configure relay operation, select '''SIP Configuration''' > '''Relay/Outputs'''. | ||
[[File: | [[File:SIP Relay Output.jpg|thumb|left|700px|Relay/Outputs]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
| Line 25: | Line 25: | ||
* '''Idle''': Choose which state the relay should change to when nothing else is occuring on the station. | * '''Idle''': Choose which state the relay should change to when nothing else is occuring on the station. | ||
* '''Error''': Choose which state the relay should change to when the station is off-line (not registered on any SIP server). | * '''Error''': Choose which state the relay should change to when the station is off-line (not registered on any SIP server). | ||
'''Multicast Paging''': | |||
*'''Multicast Paging''': Operate the relay during playback of a multicast audio stream. Available from ver. 9.4.3.1. | |||
=== Related articles === | === Related articles === | ||
Latest revision as of 10:52, 5 February 2026
To configure relay operation, select SIP Configuration > Relay/Outputs.
In Relay/Outputs you configure when a relay or output should change state. There are 4 different states: on, off, slow blinking and fast blinking. The "-" sign means that the behaviour does not change when the event occurs. The relay state can change either with a remote digit (DTMF signal) during a call, or if the station state changes.
|
As from Turbine firmware 4.11 you can choose between Basic Relay handling (in the image above), or Use Advanced Output Handler: The "Advanced Output Handler" makes it possible to better customize the relay/GPO handling to your preferences. |
Choose Relay To Configure:
- Select which relay or output to configure. The number of relays available depend on the device hardware.
- For IP-LCM, select Relay 1 to use the in-built relay on the TKIS-2 and select External Relay 1 - External Relay 8 to use the rest of the relays.
- Outputs will become available in the list after being configured as "Outputs" in the I/O Settings page.
Remote DTMF digit during call:
- Remote Digit For Relay On/Off/Slow flash/Fast flash: Choose which remote digit (DTMF signal) should change the relay to the on/off/Slow flash/Fast flash state
- Remote Digit For Relay Toggle: Toggles the relay on/off every time the specified DTMF digit is received
- Remote Digit For Relay Timed Relay On: Choose which remote digit (DTMF signal) should change the relay to the on state for a configureable number of seconds. This state is normally used for Door Opening feature.
Change of station state:
- Outgoing Ringing / Incoming Ringing: Operate the relay while the station is ringing due to an incoming or outgoing call. The ringing state occurs from the call has started until the call has been accepted.
- Outgoing Call / Incoming Call: Operate the relay while the station is in conversation. The call state occurs from the call is accepted untill the cal ends.
- Group Call (Edge mode only): Operate the relay when the station receives a group call
- Idle: Choose which state the relay should change to when nothing else is occuring on the station.
- Error: Choose which state the relay should change to when the station is off-line (not registered on any SIP server).
Multicast Paging:
- Multicast Paging: Operate the relay during playback of a multicast audio stream. Available from ver. 9.4.3.1.