Difference between revisions of "SET CALL REQ MODE"

Revision as of 15:07, 19 January 2017

SET_CALL_REQ_MODE		0x006C
$SCRM L101 L102 U0 U1
Turn on/off message "your call is registered, please wait", then ring/flashing at a station. Note that the station leaves this mode if becomes busy for some reason (dialing, incoming conv.) "Call requester mode" is normally used to inform the user about a successful activation of call request.
1	NET_OBJ_REF {ECL_STATION}	Station
2	NET_OBJ_REF {ECL_STATION}	Station that received the call request mail (i.e. sender of this command)
3	UINT1	UserDefined Properties (UDP) of the station that received the call request mail.
4	UINT1	New call requester mode: 0 = off 1 = on
5	UINT1	Mail Priority 0 - 255
6	UINT1	Mail Flags: SEND_MAIL
Response:		COMMAND_RESPONSE

@@ Line 1: / Line 1: @@
+{{A}}
 {| border="1"
 |-