STATUS REPORT

STATUS_REPORT		0x0072	114	AMC 07.30
Report equipment Presence and Error/OK status for Subscriber Lines, Audio Links, Devices, Boards, etc. Intended for remote logging and external monitoring systems. As the message is very general, the message definition will be followed by a detailed example of how the different parameters are used for each “entity” type. Unused parameters/flags are always set to 0. AlphaCom can be programmed to forward STATUS_REPORT messages to two addresses. See Exchange_&_System_(AlphaPro)#Logs_and_Errors, "System Log and Error Reports to".
1	NET_OBJ_REF<br\> {ECL_STATION,<br\> ECL_AUDIO_RING,<br\> ECL_AUDIO_LINK,<br\> ECL_BOARD,<br\> ECL_DEVICE,<br\> ECL_NODE}	Entity Reference to the Station / Inter­Exchange Link / ICC Audio Ring / Board / Device / Exchange the status message is for.<br\>The entity number is a logical number, e.g. station from 1 to 552.
2	NET_OBJ_REF<br\> {NRF_PHYS_ADDR}	Physical address for the entity defined in parameter 1.<br\>This is a hardware module/board/port type of information.
3	BITMAP[1..8]	(Error) State Flags.<br\>Bit 1 = Interface present:<br\>Bit 2 = Interface test:<br\>Bit 4 = Signaling test: Bit 6 = Audio test:<br\>Bit 7 = Device dependent test	<br\>Board present in exchange<br\>Board reports entity missing/down<br\>Last signaling test failed<br\>Last audio (tone) test failed<br\>
4	BITMAP[1..8]	(State) Change Flags.<br\>Each bit is set if the corresponding state flag bit was changed from the previous report and cleared if it was unchanged.
5	BITMAP[1..8]	Reporting Flags.<br\>Bit 8 = VERBOSE. The report is from a manually/externally started test, where the user wants a complete report.
6	UINT1	Extra (Error) Status Information 1.
7	UINT1	Extra (Error) Status Information 2.
8	NET_OBJ_REF<br\>(optional)	Entity Information field 1.<br\>.
STATUS_REPORT for Stations:
1	NET_OBJ_REF	Station from 1 to 552.<br\>The Sub Class field specifies the type of station interface (TouchLine, Telephone).<br\>Status info. can have different meaning for each Sub Class.
2	NET_OBJ_REF	Physical address: Module/board/port.<br\>The (Implicit Type) Resource Address format is used
3	BITMAP[1..8]	(Error) State Flags.<br\>Bit 1 = Interface present:<br\>Bit 2 = Interface test:<br\>Bit 6 = Audio test:<br\>Bit 7 = Device dep. test:	---What is reported for Stations:---<br\>ASLT/ATLB board missing <br\>ASLT/ATLB wire monitoring<br\>Tone Test <br\>Handset Off-Hook timeout	(no active report)<br\>(only failures)<br\>(only changes)<br\>(only failures)
5	BITMAP[1..8]	Reporting Flags.<br\>Bit 8 = VERBOSE.	<br\>Set by Tone Test started from station.
6	UINT1	Status information 1.	Bits describing ab- and cd- wire errors
7	UINT1	Status information 2.	TouchLine: Tone test signal/noise value.<br\>Telephone: Wire monitor current.
8	NET_OBJ_REF	Entity Information field 1	Directory Number.

Back to AlphaNet message list