Difference between revisions of "EDO - External Data Output"
From Zenitel Wiki
(→See also) |
|||
| Line 2: | Line 2: | ||
EDO is controlled from the [[Event Handler]] where it can be configured to send free text merged with parameters for the active stations. | EDO is controlled from the [[Event Handler]] where it can be configured to send free text merged with parameters for the active stations. | ||
| + | |||
| + | Add EDO port number as an optional parameter before the text | ||
| + | EDO 3 ”This goes to port 3” | ||
| + | EDO 1 ”text” is equivalent to EDO ”text” | ||
| + | |||
| + | The $PUT DP message already have port parameter because $PUT 3 is EDO port 1. This is followed up by | ||
| + | $PUT 4 (EDO port 2) | ||
| + | $PUT 5 (EDO port 3) | ||
| + | $PUT 6 (EDO port 4) | ||
| + | |||
== Syntax == | == Syntax == | ||
Revision as of 20:19, 30 September 2008
EDO (External Data Output) is an user definable, output-only, ASCII HEX protocol intended for CCTV control etc.
EDO is controlled from the Event Handler where it can be configured to send free text merged with parameters for the active stations.
Add EDO port number as an optional parameter before the text EDO 3 ”This goes to port 3” EDO 1 ”text” is equivalent to EDO ”text”
The $PUT DP message already have port parameter because $PUT 3 is EDO port 1. This is followed up by $PUT 4 (EDO port 2) $PUT 5 (EDO port 3) $PUT 6 (EDO port 4)
Syntax
EDO "free text" This will send free text out on the EDO port
Example
EDO 2 "Door A2 open \x0D\x0A" Output: Door A2 open +CR+LF