Difference between revisions of "Remote setup of Alarm message feature"
From Zenitel Wiki
| Line 16: | Line 16: | ||
* 761 + 85 + 8190: Turn off alarm message to stations in group 85 | * 761 + 85 + 8190: Turn off alarm message to stations in group 85 | ||
| − | By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions. This must be done from the nvram editor in the [[TST]] | + | By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions. This must be done from the nvram editor in the [[TST console]]. |
Alarm messages can also be triggered from the [[Event Handler]] or [[RCI]] by using the commands [[AMS]] or [[AMG]], or the [[ACDP|AlphaCom Data Protocol]] command [[ALARM MSG|$ALRM]] | Alarm messages can also be triggered from the [[Event Handler]] or [[RCI]] by using the commands [[AMS]] or [[AMG]], or the [[ACDP|AlphaCom Data Protocol]] command [[ALARM MSG|$ALRM]] | ||
Revision as of 16:53, 25 January 2008
| Feature: | Remote setup of Alarm Message |
| Default directory number: | 761 |
| Feature number: | 68 |
| Parameter 1: | 0 (N/A) |
| Description: | Remotely activate playback of alarm message to another station or group of stations. The feature requires ASVP board.
Procedure:
By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions. This must be done from the nvram editor in the TST console. Alarm messages can also be triggered from the Event Handler or RCI by using the commands AMS or AMG, or the AlphaCom Data Protocol command $ALRM |
|-
|colspan="2"|Play alarm message on group of stations.
Dial: <dir.no> <group dir.no>