Difference between revisions of "AlphaCom XE1"
From Zenitel Wiki
(→Connections) |
(→Serial Ports) |
||
| Line 19: | Line 19: | ||
====Serial Ports==== | ====Serial Ports==== | ||
| − | + | Serial Port 0 - 9-Pin D-sub (RS232 Only) | |
:No additional settings necessary | :No additional settings necessary | ||
| − | + | ||
| + | ---- | ||
| + | |||
| + | Serial Port 1 - RJ45 (RS232/422/485) | ||
:Additional settings: | :Additional settings: | ||
:'''RS232:''' | :'''RS232:''' | ||
Revision as of 13:49, 3 November 2016
Highlights
- Made to provide critical communication in any environment
- Supports 552 IP stations
- Environmental friendly and energy saving - max. 4 W
- SIM card based software configuration and disaster recovery
- Fully compatible with any AlphaCom system
Additional Documentation on Zenitel.com
Connections
File:XE1 Connections.png
500px
- The exchange is normally powered from the mains via a 5 VDC power supply
- Two RJ-45 Ethernet terminals are used for IP LAN, WAN, Internet and AlphaNet IP communication. Eth0 is also used for programming
- There are two inputs for clean contacts on the RCI connectors which can execute programmable functions. Note that the cabinet needs to be opened to get access to these connectors
- The serial ports with RS232 and RS422/RS485 interfaces are used for connecting to equipment using these protocols
Serial Ports
Serial Port 0 - 9-Pin D-sub (RS232 Only)
- No additional settings necessary
Serial Port 1 - RJ45 (RS232/422/485)
- Additional settings:
- RS232:
- Switch 8 on S601 on the AMC-IP board must be set to OFF.
- RS422/485:
- Switch 8 on S601 on the AMC-IP board must be set to ON.
- Take off the top lid to reach the jumpers inside, and set them to the correct position.
- - RS485: Both jumpers in position 2-3 (default)
- - RS422: Both jumpers in position 1-2
