AlphaCom XE1

AlphaCom XE1 Audio Server with HD Voice

Highlights

• Made to provide critical communication in any environment
• Supports 552 IP stations
• Environmental friendly and energy saving - max. 4 W
• SIM card based software configuration and disaster recovery
• Fully compatible with any AlphaCom system

Connections

File:XE1 Connections.png

500px

Power

• The exchange is normally powered from the mains via a 5 VDC power supply

Network

• Two RJ-45 Ethernet terminals are used for IP LAN, WAN, Internet and AlphaNet IP communication. Eth0 is also used for programming

Serial Ports

• The serial ports with RS232 and RS422/RS485 interfaces are used for connecting to equipment using these protocols

XE1 IP and serial connections

Serial Ports

Serial Port 0 - 9-Pin D-sub (RS232 Only)

No additional settings necessary

---

Serial Port 1 - RJ45 (RS232/422/485)

Additional settings:

RS232:

• Switch 8 on S601 on the AMC-IP board must be set to OFF.

RS422/485:

• Switch 8 on S601 on the AMC-IP board must be set to ON.
• Take off the top lid to reach the jumpers inside, and set them to the correct position.

- RS485: Both jumpers in position 2-3 (default)

- RS422: Both jumpers in position 1-2

RS422/485 selector for Serial Port 1 in the XE1

RCI

• There are two inputs for clean contacts on the RCI connectors which can execute programmable functions. Note that the cabinet needs to be opened to get access to these connectors

RCO

• XE1 does not support any RCO's in the server itself. If remote control outputs are required, please use TKIS-2 kit or IP-ARIO.