Grandstream GXP2000

Enter password: admin

Set IP address

Enter AlphaCom IP address and User ID

Make sure that the phone has the latest firmware version.

Factory default settings

How to perform a Factory Reset of the GXP2000:

1. Disconnect the ethernet cable
2. Press the round MENU button to enter the menu.
3. Scroll down to CONFIG and select it (by pressing round button again)
4. Scroll down to Factory Reset and select it.
5. Move cursor to the empty space above the OK and CANCEL.
6. Enter the MAC Address with alphabets and numbers.
7. Once finished, press round button till cursor is on OK.
8. Press the round button once more to initiate the Factory Reset.
9. Reconnect the ethernet cable

The display will show the IP address of the phone.

Configuration of the phone via Web Browser

To access the phone’s Web Configuration Menu:

• Connect the computer to the same network as the phone1
• Make sure the phone is turned on and shows its IP-address
• Start a Web-browser on your computer
• Enter the phone’s IP-address in the address bar of the browser2
• Enter the administrator’s password to access the Web Configuration Menu3

The default administrator password is “admin”; the default end-user password is “123”.

NOTE: When changing any settings, always SUBMIT them by pressing the button on the bottom of the page. Reboot the phone to have the changes take effect. If, after having submitted some changes, more settings have to be changed, press the menu option needed.

Set IP address of the phone:

• Press the Menu key on the phone and scroll inside the menu with the arrow keys

Configuring the phone:

• The remaining configuration is done from the web interface
• Log on to the phone via your web-browser using the IP address entered above
• Password: admin (small letters)
• In Basic Settings the IP-address & Subnet Mask can be changed

Select Advanced Settings

• Enter the IP address of the AlphaCom E exchange
• Enter SIP User ID – must be identical to the Directory Number entered in AlphaPro
• Update and Reboot

Configuration of AlphaCom E

The AlphaCom E needs to be configured with a SIP registrar node.