Difference between revisions of "TKIV+ Dimensions & Mounting Instructions"
From Zenitel Wiki
(→TKIV+ Camera Module Dimensions) |
|||
(6 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
{{AEIS}} | {{AEIS}} | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
=Dimensions CPU module= | =Dimensions CPU module= | ||
− | [[File:TKIV CPU | + | [[File:TKIV Dim CPU.PNG|thumb|left|600px|TKIV+ CPU module dimensions]] |
<br clear=all/> | <br clear=all/> | ||
=Dimensions Camera module= | =Dimensions Camera module= | ||
− | [[File:TKIV | + | [[File:TKIV Dim Cam.PNG|border|left|600px|TKIV+ Camera Module dimensions]] |
<br clear=all/> | <br clear=all/> | ||
Line 31: | Line 20: | ||
{{note|Make sure that the distance between the CPU module and the camera unit does not exceed 50 mm so as not to strain the cable.}} | {{note|Make sure that the distance between the CPU module and the camera unit does not exceed 50 mm so as not to strain the cable.}} | ||
− | [[File:Flat_Cable_length.png|thumb|left| | + | [[File:Flat_Cable_length.png|thumb|left|600px|Flat Cable length]] |
<br clear=all/> | <br clear=all/> | ||
Latest revision as of 09:41, 10 August 2022
Contents
Dimensions CPU module
Dimensions Camera module
TKIV+ Camera Module Mounting instruction
The installation should be performed in an ESD Safe working environment using a flat-head screwdriver.
The flat cable comprises one side that has a blue tape and one side that has the contact.
Make sure that the distance between the CPU module and the camera unit does not exceed 50 mm so as not to strain the cable. |
Connecting the Flat Cable to the CPU Module
1. Use a flat-head screwdriver to release the snap locks on both short sides of the CPU module and gently pry the cover off.
|
2. Open the FFC contact on the CPU board by carefully lifting the lever at both ends.
|
3. Insert the cable into the contact with the blue tape side facing up and the contact side facing down.
|
4. Close the contact by pressing down the lever at both ends simultaneously.
|
Connecting the Flat Cable to the Camera unit
- Open the FFC contact on the camera unit by carefully lifting the lever at both ends.
- Thread the flat cable through the strain relief on the camera unit.
- Insert the cable into the contact with the contact side facing up and the blue tape side facing down.
- Close the contact by pressing down the lever at both ends simultaneously.