Operating the TEIV-1+: Difference between revisions
From Zenitel Wiki
(Created page with "{{AEIS}} == Making a call == * To make a call – you need to press “#” followed by the number to be called to and then the checkmark (v), e.g. # 201 v * To make a call us...") |
|||
| (7 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
{{AEIS}} | {{AEIS}} | ||
== Defining PIN code(s) == | == Defining PIN code(s) == | ||
| Line 9: | Line 5: | ||
[[File:TEIVcsv.png|thumb|left]] | [[File:TEIVcsv.png|thumb|left]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
* A maximum of 30 pin codes can be uploaded | |||
* When saving the CSV file the seperation character should be defined as semicolon (;). | |||
* Upload the pin code list file under the Address Book menu as shown below | * Upload the pin code list file under the Address Book menu as shown below | ||
[[File:TEIV uploadPinCodes.png|thumb|left|500px]] | [[File:TEIV uploadPinCodes.png|thumb|left|500px]] | ||
| Line 15: | Line 13: | ||
{{Note|Encrypted pin codes are stored here: http://[IP address of the station]:8080/state/config/gui/door_access_control | {{Note|Encrypted pin codes are stored here: http://[IP address of the station]:8080/state/config/gui/door_access_control | ||
Make sure port 8080 port in the device firewall is opened}} | Make sure port 8080 port in the device firewall is opened}} | ||
== Using the station == | |||
===From firmware version 8.2.3.1=== | |||
* '''Making a call''' – Dial the wanted extension number. In SIP Mode, the Check mark may be required to indicate the end of the dialing sequence | |||
* '''Call using address book''' – use the check mark after selection is done | |||
* '''Door Opening''' - Dial #, followed by your Pin Code. This will activate the built-in relay. | |||
===Prior to version 8.2.3.1=== | |||
* '''Making a call''' – Dial “#” followed by the number to be called, then the check mark (v), e.g. # 201 v | |||
* '''Call using address book''' – use the check mark after selection is done | |||
* '''Door Opening''' - Dial your Pin Code. This will activate the built-in relay. | |||
Latest revision as of 11:44, 20 June 2024
Defining PIN code(s)
- To define a pin code – create a csv file with 4 digits numbers as shown in the example below:
- A maximum of 30 pin codes can be uploaded
- When saving the CSV file the seperation character should be defined as semicolon (;).
- Upload the pin code list file under the Address Book menu as shown below
|
Encrypted pin codes are stored here: http://[IP address of the station]:8080/state/config/gui/door_access_control
Make sure port 8080 port in the device firewall is opened |
Using the station
From firmware version 8.2.3.1
- Making a call – Dial the wanted extension number. In SIP Mode, the Check mark may be required to indicate the end of the dialing sequence
- Call using address book – use the check mark after selection is done
- Door Opening - Dial #, followed by your Pin Code. This will activate the built-in relay.
Prior to version 8.2.3.1
- Making a call – Dial “#” followed by the number to be called, then the check mark (v), e.g. # 201 v
- Call using address book – use the check mark after selection is done
- Door Opening - Dial your Pin Code. This will activate the built-in relay.