Difference between revisions of "SET NODE NUMBER"
From Zenitel Wiki
| (4 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
| + | {{AI}} | ||
{| border="1" | {| border="1" | ||
|- | |- | ||
| Line 8: | Line 9: | ||
|colspan="5"|Change the node number of an exchange. To be used by service tools like [[AlphaPro]] only. | |colspan="5"|Change the node number of an exchange. To be used by service tools like [[AlphaPro]] only. | ||
|- | |- | ||
| − | |align=center|1||[[UINT1]]||colspan="3"|New node number.<br | + | |align=center|1||[[UINT1]]||colspan="3"|New node number.<br />Range 1 -> 254, otherwise the existing node number will not be changed. |
|- | |- | ||
|colspan="2"|Response: | |colspan="2"|Response: | ||
| Line 17: | Line 18: | ||
[[AlphaNet_Data_Protocol#System_Maintenance|Back to AlphaNet message list]] | [[AlphaNet_Data_Protocol#System_Maintenance|Back to AlphaNet message list]] | ||
| + | |||
| + | [[Category: ACDP messages]] | ||
Latest revision as of 15:07, 3 October 2019
| SET_NODE_NUMBER | 0x006D | 109 | AMC 07.00 | |
|---|---|---|---|---|
| Change the node number of an exchange. To be used by service tools like AlphaPro only. | ||||
| 1 | UINT1 | New node number. Range 1 -> 254, otherwise the existing node number will not be changed. | ||
| Response: | COMMAND_RESPONSE, status 1= success, status 6 = failure. | |||