Difference between revisions of "INCA Station Restore Factory Defaults"

Revision as of 16:47, 17 March 2017

This procedure is applicable for the stations:

This procedure is also applicable for these kits:

This requires that a push button is connected between pin 1 and pin 4 on connector P4.

Procedure:

Kits require a push button to be connected between pins 1 and 4

The unit can be set to use either Static IP or DHCP. Pay attention to the call LED during the restore procedure:

While pressing the call button, power up the station and keep the button pressed.
Release the button after exactly 2 flashes of the LED.
Let the LED flash for exactly 2 more times (Static IP) or exactly 4 more times (DHCP), then press the button again.
Keep the button pressed until the LED flashes fast 2 times (Static IP) or flashes fast 4 times (DHCP) indicating a successful reset.
Release the button and the station will restart with the factory default settings.

Factory default values:

* Software 01.06 and earlier: ADMIN/alphacom)

@@ Line 5: / Line 5: @@
 [[File:Load Defaults without Display - 1.PNG|right|300px]]
-This procedure is also applicable for the kits. This requires that a push button is connected between pin 1 and pin 4 on connector P4.
+This procedure is also applicable for these kits:
 * [[IP Master Station Kit - 1008093000]]
 * The [[IP Substation Kit - 1008090200]]
+This requires that a push button is connected between pin 1 and pin 4 on connector P4.
+'''Procedure:'''
 [[File:Load Defaults without KEY.PNG|left|thumb|300px|Kits require a push button to be connected between pins 1 and 4]]
 [[File:Load Defaults without Display - 2.PNG|right|300px]]