Difference between revisions of "INCA Station Restore Factory Defaults"

Revision as of 16:51, 17 March 2017

The unit can be set to use either Static IP or DHCP. This procedure is applicable for the stations:

This procedure is also applicable for these kits:

This requires that a push button is connected between pin 1 and pin 4 on connector P4.

Kits require a push button to be connected between pins 1 and 4

Procedure:

While pressing the call button, power up the station and keep the button pressed.
Release the button after exactly 2 flashes of the LED.
Let the LED flash for exactly 2 more times (Static IP) or exactly 4 more times (DHCP), then press the button again.
Keep the button pressed until the LED flashes fast 2 times (Static IP) or flashes fast 4 times (DHCP) indicating a successful reset.
Release the button and the station will restart with the factory default settings.

Factory default values:

* Software 01.06 and earlier: Username/password isADMIN/alphacom

@@ Line 6: / Line 6: @@
 [[File:Load Defaults without Display - 2.PNG|right|300px]]
 This procedure is also applicable for these kits:
-* [[IP Master Station Kit - 1008093000]]
+* [[IP Master Station Kit - 1008093000|300px]]
-* The [[IP Substation Kit - 1008090200]]
+* The [[IP Substation Kit - 1008090200|300px]]
 This requires that a push button is connected between pin 1 and pin 4 on connector P4.
 [[File:Load Defaults without KEY.PNG|left|thumb|300px|Kits require a push button to be connected between pins 1 and 4]]