Difference between revisions of "INCA IP DualDisplay Station - Restore Factory Defaults"
From Zenitel Wiki
(→Load factory defaults via power boot sequence) |
|||
Line 22: | Line 22: | ||
== Load factory defaults via power boot sequence == | == Load factory defaults via power boot sequence == | ||
− | + | [[File:DualDisplay Privacy.png|thumb|300px|right|Location of the Privacy button]] | |
The unit can be set to use either '''Static IP''' or '''DHCP'''. Pay attention to the station LED during the restore procedure: | The unit can be set to use either '''Static IP''' or '''DHCP'''. Pay attention to the station LED during the restore procedure: | ||
Line 30: | Line 30: | ||
# Keep the button pressed until the LED '''flashes fast 2 times''' (Static IP) or '''flashes fast 4 times''' (DHCP) indicating a successful reset. | # Keep the button pressed until the LED '''flashes fast 2 times''' (Static IP) or '''flashes fast 4 times''' (DHCP) indicating a successful reset. | ||
# Release the button and the station will restart with the factory default settings. | # Release the button and the station will restart with the factory default settings. | ||
− | |||
Line 38: | Line 37: | ||
*Username: '''admin''' | *Username: '''admin''' | ||
*Password: '''alphaadmin''' | *Password: '''alphaadmin''' | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
[[Category: INCA - Restore Factory Defaults and Software Upgrade]] | [[Category: INCA - Restore Factory Defaults and Software Upgrade]] |
Revision as of 14:37, 17 March 2017
The IP DualDisplay station can be reset to Factory Default settings in two ways:
- From the display menu
- By a power boot sequence
The Station Menu is available when the IP Station is in offline mode. i.e. not registered to the server.
- Press the Setup button beneath the display
- Enter the password 1851 and press the Ok button.
- Navigate to Load defaults and press the Sel button.
- Press the Sel button to load factory defaults.
The station will now restart with factory settings:
- Station Mode: Pulse
- Station IP address: 169.254.1.100
- Username: admin
- Password: alphaadmin
Load factory defaults via power boot sequence
The unit can be set to use either Static IP or DHCP. Pay attention to the station LED during the restore procedure:
- While pressing the Privacy button, power up the station kit and keep the button pressed.
- Release the button after exactly 2 flashes of the LED.
- Let the LED flash for exactly 2 more times (Static IP) or exactly 4 more times (DHCP), then press the button again.
- Keep the button pressed until the LED flashes fast 2 times (Static IP) or flashes fast 4 times (DHCP) indicating a successful reset.
- Release the button and the station will restart with the factory default settings.
Factory default values:
- Station Mode: Pulse
- Station IP address: 169.254.1.100 or DHCP
- Username: admin
- Password: alphaadmin